YBT (N) type oil cold motor-driven roller, this product is DT type, type DTII general stationary belt conveyor is inside the device drivers, and by motor and reducer, transmission roller combined with external drives, compared with small space, light weight, reliable performance, neat appearance etc, and on the dust, wet muddy such harsh conditions can still work normally.

Electric roller note:

1. Before the use should check whether the roller internal fuel, the amount of oil with roller radius 2/3 advisable; Check electrical wiring is correct.

2. Drum shall no-load startup.

3. Roller first working 300 hours after the replacement in the cylinder lubricants (grades for oil cold pattern and built-out type for N46 JiXieYou, old standard 30 #. Oil-immersed for L - CKC150 negative load in extreme pressure industrial gear oil), then every 5000 hours oil once and maintenance. 4. Check regularly oil level, according to the conditions of sealing adjusting oil seal spring or replace seal.

About roller type code some explanation:

(1) electrical installation mode and cooling way: motor built-in usually marked motor cooling modes: the oil cold pattern (Y), oil-immersed (J) motor built-out bold motor installation forms: horizontal motor inline type (WI), vertical motor straight league type (WII), horizontal motor ChuiZhiXing (WIII)

(2) transmission form code: fixed axis gear transmission (D) (hard-toothed surface fixed axis gear marking A), cycloidal pinwheel transmission (Z) (power to subscript B), 30kw planetary gear transmission (X)

(3) special performance code: universal (T don't mark), non-return type (N), mobile type (YI hand everywhere or YII), explosion-proof type (B), anti-corrosion type (F); etc.

(4) when the roller bearings, namely need tilt installation bottom plane and ground or horizontal plane into a Angle shall, when the motor installed form or cooling way after subscript a obliquity numerical code than before, but in numerical add "left or right (make sure the methods: built-in from qualify depends, external extended from motor end see, drum body left-leaning for" left ", upright for "right"). If not marked as normal (horizontal) installation. Because of this and the roller service performance and lubrication performance has a direct effect, so please user selection should be clearly in the contract.